Ruijie Networks RG-S2600E Series Cli Reference Manual page 142

S2600E/P CLI Reference Guide
Examples
Related
commands
4.2 Showing Related Command
4.2.1 show lacp summary
Use this command to show the LACP aggregation information.
show lacp summary [key]
Parameter
description
Command
mode
Usage
guidelines
Example
s
Chapter 4 LACP Configuration Commands
the higher the priority is. All LACP groups on the switch
share the system priority. Changing the system priority
may influence the whole aggregation groups on the switch.
Ruijie(config)# lacp system-priority 4096
Command
port-group key mode
｛active | passive｝
lacp port-priority
Parameter
key
Privileged mode.
N/A.
Ruijie# show LACP summary
Flags:S - Device is sending Slow LACPDUs
fast LACPDUs.
A - Device is in active mode.
Aggregate port 3:
Local information:
LACP port
Description
Enable the LACP on the port
and specify the aggregation
group ID and operation mode.
Set the LACP port priority.
Description
Specify the aggregation group id to
show. If it is not
aggregation group information is shown
by default.
F - Device is sending
P - Device is in passive mode.
Oper Port
specified, all
Port