Ruijie Networks RG-S2600E Series Cli Reference Manual page 967

S2600E CLI Reference Guide
2.1.2 rldp detect-interval
Use this command to configure the interval at which the RLDP sends the
detection message on the port. Use the no form of this command to restore it to
the default value.
rldp detect-interval interval
no rldp detect-interval
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Related
commands
2.1.3 rldp detect-max
Use this command to set the maximum number of sending detection packets on
the port. If the neighboring port does not respond when this detection number is
exceeded, the link is considered faulty. Use the no form of this command to
restore it to the default value.
rldp detect-max num
no rldp detect-max
Chapter 2 RLDP Configuration Command
Parameter Description
interval Detection interval in the range 2 to 15
seconds
3 seconds.
Global configuration mode.
In the environment where STP is enabled, it is
recommended that the product of interval multiplying the
maximum number of detections is less than the topology
convergence time of STP.
The following example shows how to set the detection
interval as 5s:
Ruijie(config)# rldp detect-interval 5
Command Description
rldp
Set the maximum number of detections.
detect-max