Ruijie Networks RG-S2600E Series Cli Reference Manual page 141

S2600E/P CLI Reference Guide
Examples
Related
commands
4.1.3 lacp system-priority
Use this command to set the LACP system priority. The no form of it restores it
to the default.
lacp system-priority system-priority
no lacp system-priority
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Chapter 4 LACP Configuration Commands
%LACP-5-UNBUNDLE_FAIL: Interface FastEthernet 0/1
failed to leave the AggregatePort 1. In this case, please
modify the configuration to cancel the related configuration
of forbidding the member ports to leave the AP, otherwise
the normal packets transmission on the AP will be
influenced.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# lacp port-priority 4096
Command
port-group key mode
｛active | passive｝
Parameter
system-priority
By default, the system priority is 32768.
Global configuration mode.
LACP system priority consists of the Layer2 management
MAC address and its priority value, where the MAC
address is fixed but the priority value is configurable. If two
priorities are equal, then the smaller the MAC address is,
Description
Enable the LACP on the port
and specify the aggregation
group ID and operation
mode.
Description
The LACP system priority, in
the range of 0-65535.