S2600E/P CLI Reference Guide
Command
mode
Usage
guidelines
Example
s
Chapter 1 IP Address Configuration Commands
Privileged mode.
When an interface is available, RGOS will create a direct
route in the routing table. The interface is available in that
the RGOS software can receive and send packets through
this interface. If the interface changes from available status
to unavailable status, the RGOS software removes the
appropriate direct route from the routing table.
If the interface is unavailable, i.e. two-way communication
is allowed, the line protocol status will be shown as "UP". If
only the physical line is available, the interface status will
be shown as "UP".
The results shown may vary with the interface type,
because some contents are the interface-specific options.
Presented below is the output of show ip interface brirf:
Ruijie# show ip interface brief
Interface
Status
GigabitEthernet 0/10 2.2.2.2/24
GigabitEthernet 0/11 no address
VLAN 1
Presented below is the output of show ip interface vlan
SwitchA#show ip interface vlan 1
VLAN 1
IP interface state is: DOWN
IP interface type is: BROADCAST
IP interface MTU is: 1500
IP address is:
1.1.1.1/24 (primary)
IP address negotiate is: OFF
Forward direct-broadcast is: OFF
ICMP mask reply is: ON
Send ICMP redirect is: ON
Send ICMP unreachabled is: ON
DHCP relay is: OFF
Fast switch is: ON
Help address is:
IP-Address(Pri)
3.3.3.3/24
no address
1.1.1.1/24
no address
IP-Address(Sec)
DOWN
DOWN
DOWN
Need help?
Do you have a question about the RG-S2600E Series and is the answer not in the manual?
Questions and answers