Ruijie Networks RG-S2600E Series Cli Reference Manual page 277

S2600E/P CLI Reference Guide
Usage
guidelines
Examples
Related
commands
3.1.13 ipv6 nd ra-interval
Use this command to set the interval of sending the RA. Use the no form of this
command to restore it to the default setting.
ipv6 nd ra-interval {seconds | min-max min_value max_value}
no ipv6 nd ra-interval
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Chapter 3 IPv6 Configuration Commands
It is used to set the hopcount of the RA message.
Ruijie(config -if)# ipv6 nd ra-hoplimit 110
Command Description
show ipv6
Show the interface information.
interface
ipv6 nd
Set the lifetime of the device.
ra-lifetime
ipv6 nd Set the interval of sending the RA
ra-interval message.
ipv6 nd ra-mtu Set the MTU of the RA message.
Parameter Description
Interval of sending the RA message in
seconds
seconds, 3-1800s.
Maximum
min-max
sending the RA message in seconds
Minimum interval sending the RA
min_value
message in seconds
Maximum interval sending the RA
max_value
message in seconds
200s. The actual interval of sending the RA message will
be fluctuated 20% based on 200s.
Interface configuration mode.
If the device serves as the default device, the set interval
shall not be longer than the lifetime of the device. Besides,
and minimum interval