Ruijie Networks RG-S2600E Series Cli Reference Manual page 977

S2600E CLI Reference Guide
3.1.2 tp-guard port enable
Use this command to enable the topology protection function on the port. Use
the no form of this command to disable the function.
[no] tp-guard port enable
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
3.2 Showing Related Commands
3.2.1 show tpp
Use this command to show the configuration of topology protection.
show tpp
Chapter 3 TPP Configuration Commands
N/A.
N/A.
Interface configuration mode.
If both the global topology protection function and the
topology protection function of the port are enabled, the
remote device of this port will be notified when the CPU
utilization of the local device is too high or there are other
problems with the local device. This command is
applicable to the layer 2 switching interfaces and routing
interfaces. Other interfaces (including AP member port) do
not support this command.
The following example shows how to configure the
topology protection function for the port:
Ruijie(config-if)# tp-guard port enable
Ruijie(config-if)# no tp-guard port enable
Command Description
topology Enable the topology protection function
guard globally.