Ruijie Networks RG-S2600E Series Cli Reference Manual page 346

S2600E CLI Reference Guide
Usage
guidelines
Examples
Related
commands
1.1.13 snmp-server trap-timeout
Use this command to define the retransmission timout time of the SNMP trap
message in the global configuration mode. The no form of this command is
used to restore it to the default value.
snmp-server trap-timeout seconds
no snmp-server trap-timeout
Parameter
description
Default
configuration
Command
mode
Examples
Related
Chapter 1 SNMP Configuration Command
By default, the IP address of the interface where the NMP
message is sent from is just the source address. For easy
management and identification, this command can be
used to fix a local IP address as the SNMP source
address.
The example below specifies the IP address of Ethernet
interface 0 as the source of the SNMP trap message:
Ruijie(config)# snmp-server trap-source fastethernet 0
Command Description
snmp-server Enable the sending of the SNMP trap
enable traps message.
snmp-server Specify the NMS host to send the
host SNMP trap message.
Parameter Description
Timeout ( in seconds) of retransmit the
seconds
SNMP trap message
30s.
Global configuration mode.
The example below specifies the timeout period as 60
seconds.
Ruijie(config)# snmp-server trap-timeout 60
Command Description