Ruijie Networks RG-S2600E Series Cli Reference Manual page 899

S2600E CLI Reference Guide
1.1.5 ip access-group
Use this command to apply a specific ACL to an interface. The no form of this
command cancels the application.
ip access-group {id|name} {in|out} [unreflect | reflect]
no ip access-group {id|name} {in|out}
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
Chapter 1 ACL Configuration Commands
Parameter Description
ID of the IP ACL (1 to 199, 1300 to
id
2699)
Name of the IP ACL
name
Filter the incoming packets of the
in
interface.
Filter the outgoing packets of the
out
interface.
Disable the Reflexive-ACL.
unreflect
Enable the Reflexive-ACL.
reflect
No ACL is applied on the interface.
Interface configuration mode.
Use the ip access-group command to apply the specified
ACL to the interface, when the firewall is enabled.
The following example applies the ACL 120 on the
fastEthernet0/0 to filter the incoming packets:
Ruijie(config)# interface fastEthernet 0/0
Ruijie(config-if)# ip access-group 120 in
Command
access-list
show access-lists
show ip access-list
Description
Define the ACL.
Show all the ACLs.
Show the IP ACL (1 to 199, 1300