Ruijie Networks RG-S2600E Series Cli Reference Manual page 27

S2600E/P CLI Reference Guide
Commands
Usage
guidelines
Examples
Related
commands
2.1.19
To log in one server which supports the telnet connection, use the telnet
command to log on in the EXEC (privileged) mode.
telnet host [port] [/source {ip
interface-name}] [/vrf vrf-name]
Parameter
description
Command
mode
This command is disabled by default. Various passwords
are displayed in form of plain text, unless it is directly
configured in cipher text form. After you execute the
service password-encryption and show running or
write command to save the configuration, the password
transforms into cipher text. If you disable the command,
the password in cipher text cannot be restored to plain text.
The example below encrypts the password:
Ruijie(config)# service password-encryption
Command
enable password
telnet
Parameter
host
port
/source
ip A.B.C.D
ipv6
X:X:X:X::X
interface
interface-name
/vrf vrf-name
Privileged mode.
Chapter 2 Switch Management Configuration
Description
Set passwords of different privileges.
| ipv6
A.B.C.D X:X:X:X::X
Description
The IP address of host or host name to
be logged in.
Select the TCP port number to be used
for the login, 23 by default.
Specify the source IP or source interface
used by the Telnet client.
Specify the source IPv4 address used by
the Telnet client.
Specify the source IPv6 address used by
the Telnet client.
Specify the source interface used by the
Telnet client.
Specify the VRF routing table to be
queried.
| interface