Ruijie Networks RG-S2600E Series Cli Reference Manual page 796

S2600E CLI Reference Guide
Examples
Related
commands
15.3.4 dhcp-guard monitor-period
Use this command to configure the monitor time.
dhcp-guard monitor-period seconds
Parameter
description
Default
Settings
Command
mode
Usage
guidelines
Examples
Chapter 15 NFPP Configuration Commands
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard isolate-period 180
Command
nfpp dhcp-guard
isolate-period
show nfpp
dhcp-guard summary
Parameter Description
seconds
Set the monitor time, in seconds. The
valid range is [180, 86400].
600s
NFPP configuration mode.
When the attacker is detected, if the isolate period is
0, the attacker will be monitored by the software and the
timeout time will be the monitor period. During the
software monitoring, if the isolate period is not 0, the
software-monitored attacker will be auto-isolated by the
hardware and the timeout time will be the isolate period.
The monitor period is valid with the isolate period 0.
If the isolate period has changed to be 0, the
attackers on the interface will be removed rather than
being monitored by the software.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard monitor-period 180
Description
Set the isolate time on the
interface.
Show the configurations.