Ruijie Networks RG-S2600E Series Cli Reference Manual page 569

S2600E CLI Reference Guide
Default No fail VLAN by default.
Command
mode Interface configuration mode.
Usage Use show dot1x interface command to show the
guidelines configurations.
The following example demonstrates how to set the
802.1X authentication fail vlan.
Ruijie# configure terminal
Examples
Ruijie(config)# interface fa 0/1
Ruijie(config-if)# dot1x auth-fail vlan 2
Ruijie(config)# end
Ruijie#write
Command
Related
show dot1x
commands
interface
4.5.5 dot1x auth-mode
Use this command to specify the 802.1x authentication mode.
dot1x auth-mode {eap-md5 | chap | pap}
no dot1x auth-mode
Parameter
eap-md5
Parameter
description
chap
pap
Default EAP-MD5 mode.
Command
mode Global configuration mode.
Usage Use the show dot1x command to show the 802.1X
guidelines configurations.
Chapter 4 802.1X Configuration Commands
Description
Show the 802.1x configurations on the
interface.
Description
Use EAP-MD5 for authentication.
Use CHAP for authentication.
Use PAP for authentication.