Ruijie Networks RG-S2600E Series Cli Reference Manual page 554

S2600E CLI Reference Guide
4.1.3 dot1x auto-req
req-interval
Use this command to set the interval of sending authentication request messages. The no
form is used to specify the default value.
dot1x auto-req req-interval interval
no dot1x auto-req req-interval
Parameter
Parameter
description
interval
Default 30 seconds.
Command
mode Global configuration mode.
Usage Use the show dot1x auto-req command to view the
guidelines setting of this function.
The following example sets the time interval of sending
authentication request message to 60s:
Ruijie# configure terminal
Ruijie(config)# dot1x auto-req req-interval 60
Ruijie(config)# end
Examples
Ruijie# show dot1x auto-req
Auto-Req: Enabled
User-Detect : Enabled
Packet-Num : 0
Req-Interval: 60 Second
Command
Related
show dot1x
commands
auto-req
4.1.4 dot1x auto-req user-detect
Use this command to disable the device to send authentication request message after
receiving the response. The no form is used to specify the default value.
dot1x auto-req user-detect
Chapter 4 802.1X Configuration Commands
Description
The time interval of actively sending
authentication request messages by the
device, in second.
Description
Show the authentication request
information.