Ruijie Networks RG-S2600E Series Cli Reference Manual page 273

S2600E/P CLI Reference Guide
3.1.9 ipv6 nd other-config-flag
Use this command to set "other stateful configuration" flag bit of the RA
message. Use the no form of this command to delete the flag bit.
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Examples
Related
commands
3.1.10 ipv6 nd ns-interval
Use this command to set the interval for the interface to retransmitting NS
(Neighbor Solicitation). Use the no form of this command to restore it to the
default setting.
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
Chapter 3 IPv6 Configuration Commands
Parameter Description
- -
The flag bit is not set by default.
Interface configuration mode.
With this flag bit set, the flag bit of the RA message sent by
the device is set. After receiving this flag bit, the host uses
the dhcpv6 to acquire the information excluding the IPv6
address for the purpose of automatic configuration. When
the managed address configuration is set, the default
other stateful configuration is also set.
Ruijie(config-if)# ipv6 nd other-config-flag
Command Description
show ipv6
Show the interface information.
interface