Ruijie Networks RG-S2600E Series Cli Reference Manual page 816

S2600E CLI Reference Guide
Usage
guidelines
Examples
Related
commands
15.5.6 icmp-guard rate-limit
Use this command to set the rate-limit threshold globally.
icmp-guard rate-limit { per-src-ip | per-port} pps
Parameter
description
Default
Settings
Command
mode
Chapter 15 NFPP Configuration Commands
If the monitored host number has reached the default
1000, the administrator shall set the max-number smaller
than 1000 and it will prompt the message that
value that you configured is smaller than current
monitored hosts 1000, please clear a part of monitored
to remind the administrator of the invalid
hosts.
configuration and removing the monitored hosts.
When the maximum monitored host number has been
exceeded, it prompts
NFPP_ARP_GUARD-4-SESSION_LIMIT: Attempt to exceed limit
of 1000 monitored hosts.to
Ruijie(config)# nfpp
Ruijie(config-nfpp)#
200
Command
show nfpp icmp-guard
summary
Parameter Description
Set the rate limit for each source IP
per-src-ip
address.
per-port
Set the rate limit for each port.
Set the rate limit, in the range of
pps
[1,9999]
The default rate-limit threshold for each source IP address
is half of the value for each port.
NFPP configuration mode.
the message
remind the administrator.
icmp-guard monitored-host-limit
Description
Show the configurations.
%ERROR：The
that
%