Dark Current Exposure (3D) - Sirona ORTHOPHOS SL 2D Service Manual

10 Maintenance
10.11 Test exposures/Test images
456
6. Press the release button. Press and hold down the button until the
exposure is complete, the preview image is displayed in the exposure
window, and the acoustic signal that indicates the end of the
exposure (double beep) sounds (if configured).
7. Read the dose shown on the Mult-O-Meter.
8. Remove the Mult-O-Meter from the sensor unit again.
10.11.3.9

Dark current exposure (3D)

You can use the
1. Call menu
2. In the structure tree, under
current exposure"
In the action area, the menu appears for creating the
current exposure"
3. Click on the
Exposure readiness is established. A dialog window displays the
status of readiness to exposure.
The service routine used for the corresponding exposure is
displayed on the control panel, along with the specific exposure
parameters.
4. Press the release button. Press and hold down the button until the
exposure is complete, the preview image is displayed in the exposure
window, and the acoustic signal that indicates the end of the
exposure (double beep) sounds (if it has been configured).
The exposure is displayed in the exposure window.
"Dark current exposure"
"Control exposures"
[ → 428].
"2D control exposures"
element.
.
"Start acquisition"
button.
Sirona Dental Systems GmbH
Service Manual ORTHOPHOS SL
to check the flat panel detector.
"Dark
, select the
"Dark
64 95 258 D3632
D3632.076.01.03.02 09.2016