S018: Test Step 10 - Sirona ORTHOPHOS SL 2D Service Manual

Sirona Dental Systems GmbH
Service Manual ORTHOPHOS SL
Adjusting and saving the PWM index
values
64 95 258 D3632
D3632.076.01.03.02 09.2016

S018: Test step 10

8.1.15.9
NOTE: In order to execute this service routine, the occlusal bite block
First execute SR S017.18
function must be activated via service routine S017.18[ → 288].
Setting the PWM values for the height adjustment creep speed
In user mode, check whether a correction is required for the speed for
upward and downward movement (creep speed). Here the bite block
must be deflected in such a way that the creep speed is effective in the
relevant direction (observe green arrows). The PWM index values are set
correctly if:
● the drive runs at approximately the same speed in both directions
● the drive spontaneously starts without jolting and concurrent to key
actuation
● the travel speed does not exceed 5 mm/s.
Symbol on the control
panel
Patient symbol key 1 (G) visible
Selection field
1
2
* factory settings
1. Call service routine S018.10.
The PWM index for upward travel "U" (up) is displayed in
selection field 1.
The PWM index for downward travel "D" (down) is displayed in
selection field 2.
The display of patient symbol key 1 (G) indicates whether or not
the occlusal bite block is connected (see table).
2. Select the desired index values using the arrow keys in selection
fields 1 and 2 (see table).
3. To save the index values, first press the Memory key (the R key lights
up) and then the R key.
4. Exit the service routine.
8.1 Perform service routines via the control panel
Status Meaning
Occlusal bite block
connected
not visible Occlusal bite block not
connected
Parameters Range of values
U (upward travel) 1U – 15U* – 35U
D (downward travel) 1D – 20D* – 35D
8 Service routines
299