Operation; Setting The Acquisition System To 3D Camera; General - Sirona Cerec AC Operating Instructions Manual

7 Operation

7.1 Setting the acquisition system to 3D camera

34
Operating Instructions for the Acquisition Unit Sirona Dental CAD/CAM System
7
Operation
Operation
7.1
Setting the acquisition system to 3D camera
✔
Handling instructions Setting the acquisition system to 3D camera To use the 3D camera, the acquisition system must be set to
camera"
.
✔
You can only execute the following settings if the
"Master Mode"
changed to
1. In the menu line, select the command
"Acquisition system"
"Configuration"
 The
"3D camera"
2. Select
 The 3D camera will remain selected until it is set back to
"inEos"
or .
7.2

General

General
Aligning the Bluecam
The direction of acquisition must
coincide with the insertion axis of
the preparation prepared by the
dentist.
right
Depth of focus and focusing
The telecentric optics, which cause objects to be displayed with a
constant size regardless of how far away from the prism they are, have a
depth of focus which is sufficient to capture deep preparations.
The image definition is determined by the distance between the Bluecam
and the preparation.
Sirona Dental Systems GmbH
.
"Settings"
.
window appears.
"OK"
and confirm with .
If the Bluecam is held at an oblique
angle to the prepared insertion
axis, the wall closer to the lens will
be registered with an undercut; the
wall further away from the lens will
be fully displayed, thus causing
the occlusal margin angle to be
presented unfavorably there and
obstructing the automatic margin
detection.
wrong
D3492.201.01.09.23 09.2011
"3D
"Settings"
menu is
/ "Configuration" /
"Scanner"
63 33 582 D3492