Adjusting The Laser Light Localizer Fh (Pan) - Sirona ORTHOPHOS SL 2D Service Manual

9 Repair
9.7 Laser light localizers
A
354
6. Loosen the screws (B) and carefully pull the laser module (C) out of
the holder toward the front.
7. Insert the new laser module (FH) in the holder and retighten screws
(B).
IMPORTANT
Make sure that the lines in the laser module run vertically.
8. Screw the holder securely back onto the cover with screws (A) and
reattach the strain reliefs.
9. Set the "Front slide" cover down on the "Top support" cover.
10. Plug the cable of the FH laser module into the sockets of cable L14.
11. Now adjust the FH (PAN) laser localizer [ → 354].
12. Reattach the "Front slide" cover [ → 37].

Adjusting the laser light localizer FH (PAN)

9.7.1.2
1. Insert the forehead and temple supports.
2. Switch the unit on via the switch (A) (see also Operating Instructions).
B
C
3. Touch the PAN symbol at the top of the touchscreen.
4. Touch the R key on the touchscreen.
5. Affix a piece of white cardboard between the temple supports.
The X-Ray radiation indicator (B) lights up briefly.
After approx. 2 seconds, the green LED (C) in the upper part of
the control panel lights up. This LED remains lit as long as the
unit is on.
The start screen appears on the touchscreen of the Easypad and
the system's self-adjustment routine starts running (for approx. 1
minute). The diaphragm moves into position. Forehead and
temple supports on the panoramic unit are moved to the home
position.
On completion of the self-adjustment routine, the main menu
appears on the touchscreen. Help message H301 prompts you to
move the unit into the starting position.
The program group PAN is selected.
The unit moves to its starting position for PAN exposures.
Sirona Dental Systems GmbH
Service Manual ORTHOPHOS SL
64 95 258 D3632
D3632.076.01.03.02 09.2016