Sirona ORTHOPHOS SL 2D Service Manual page 95

Sirona Dental Systems GmbH
Service Manual ORTHOPHOS SL
Error code Description
E5 11 09 Internal error in program sequence
of board DX11.
Error code Description
E1 11 10 The unit is currently operating in the
factory setting.
It is possible to generate exposures.
Error code Description
E7 11 11 Wrong unit configuration.
Error code Description
E6 11 13 The release button was not properly
detected.
Error code Description
E7 11 14 Wrong remote control for this unit.
This error message blocks all unit
functions. To continue to work with
this unit, you must unplug the
remote control and restart the unit.
Error code Description
E1 11 18 Calibration of the occlusal bite block
is required.
Error code Description
E1 11 19 The welcome screen is not shown.
64 95 258 D3632
D3632.076.01.03.02 09.2016
Actions required
E5 11 09
● Acknowledge error and repeat procedure.
If the error occurs repeatedly ...
● Perform a software update (bug fix).
Actions required
E1 11 10
● Please contact the Sirona Customer
Service Center (CSC).
Actions required
E7 11 11
● Check the unit configuration by running
service routine S017.2 and reconfigure if
necessary.
Actions required
E6 11 13
● Restart the unit:
1. Switch off the unit.
2. Wait 1 minute.
3. Switch unit on.
4. Repeat procedure.
If the error occurs again ...
● Replace release button incl. cable.
● Replace board DX1.
● Replace board DX42.
Actions required
E7 11 14
● Install the correct remote control.
● If necessary, obtain a new remote control
from the manufacturer.
A remote control for another Sirona unit or a
third-party manufacturer unit may have been
connected.
Actions required
E1 11 18
● Run service routine S018.9.
● If necessary, run service routine S018.7 to
make customer-specific angle settings.
Actions required
E1 11 19
● Check compatibility with SIDEXIS 4.
5 Messages
5.4 List of error messages
see
S. [ → 68]
see
see
S. [ → 278]
see
S. [ → 395]
see
see
S. [ → 297],
S. [ → 293]
see
S. [ → 45]
95