Checking The Can Bus - Sirona ORTHOPHOS SL 2D Service Manual

Sirona Dental Systems GmbH
Service Manual ORTHOPHOS SL
Entry data [DeviceError]
Entry data
[Error Sidexis]
Entry data [Stringname]
Entry data [Stringsegment]
Entry data
[RTC Date / Time Change]
Entry data
[PC Date / Time]
Entry data
[Error Sidexis]
64 95 258 D3632
D3632.076.01.03.02 09.2016
DEV_DX42
Byte 0-7:
0x10 0x00 0x00 0x00 0x00 0x00 0x00
0x00
SidErr: ERR_SOCKET_ERROR
SockErr:
Key Act
Key Ok
7YFWDUFV-E4MMRJBW
061-00133
Tried to change to:
YYYY-MM-DD, HH:MM:SS
YYYY-MM-DD, HH:MM:SS
Automatic version update started,
VXX.XX.XX -> VXY.XY.XY
Software update terminated,
result: XXX
6.2

Checking the CAN bus

NOTICE
Risk of damage to unit
The power supply MUST be plugged in and switched on when cables
are attached and plugged in. For example, if no power cable is
connected to the DX91 ceph, the module has no ground connection to
the unit and there is no potential equalization. If the CAN cable is
plugged in, the CAN transceiver (IC on the DX91) can be destroyed by
the voltage difference. In other words, when the unit is switched on, CAN
cables may only be plugged in on modules that are connected to the
power source and ground.
For troubleshooting, you can disconnect the CAN bus cable and/or plug
it back in and observe the (unit's) behavior.
To check the fiber-optic cables, a fiber test device, e.g.
®
Fiberpoint 250MD can be used [ → 13].
6.2 Checking the CAN bus
Name of module to which the message
refers
Detailed error bytes for an error
occurrence
Detail of network error (for Sirona only)
Detail of network error (for Sirona only)
Activation transaction
Activation transaction
E.g. activation or confirmation code (for
activation transaction)
E.g. counter (ID counter reading)
E.g. tried to change to:
2006-Nov-30, 11:32:13
2006-Nov-30, 11:32:13
E.g. automatic version update
started, V05.07.07 -> V24.51.03
E.g. software update terminated,
result: ok
6 Troubleshooting
141