Route Map Commands - Dell S4810 Reference Manual

Route Map Commands

When you create an access-list without any rule and then applied to an interface, the ACL behavior
reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
S4810
Syntax
continue [sequence-number]
Parameters
sequence-
number
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage The continue feature allows movement from one route-map entry to a specific
Information route-map entry (the sequence number). If you do not specify the sequence
number, the continue feature simply moves to the next sequence number (also
known as an implied continue). If a match clause exists, the continue feature
executes only after a successful match occurs. If there are no successful matches,
the continue feature is ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without
a match clause executes and jumps to the specified route-map entry.
Access Control Lists (ACL)
(OPTIONAL) Enter the route map sequence number. The
range is from 1 to 65535.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
269