Route Map Commands - Dell Z9500 Command Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Example
Dell#show ip prefix summary
Prefix-list with the last deletion/insertion: test
ip prefix-list test:
count: 3, range entries: 1, sequences: 5 - 15
ip prefix-list test1:
count: 2, range entries: 2, sequences: 5 - 10
ip prefix-list test2:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test3:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test4:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test5:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test6:
count: 1, range entries: 1, sequences: 5 - 5
Dell#

Route Map Commands

When you create an access-list without any rule and then applied to an interface, the ACL behavior
reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
304
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Access Control Lists (ACL)