Primary-Priority; Show Vlt Brief - Dell Z9500 Reference Manual

primary-priority

Assign the priority for master election among VLT peers.
Z9500
Syntax
[no] primary-priority
Parameters
value
Default 32768
Command VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.8.0
Usage After you configure the VLT domain on each peer switch on both sides of the
Information interconnect trunk, by default, the Dell Networking OS software elects a primary
and secondary VLT peer device. To reconfigure the primary role of VLT peer
switches, use the priority command.

show vlt brief

Displays summarized status information about VLT domains currently configured on the switch.
Z9500
Syntax
show vlt brief
Default Not configured.
1804
To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
Description
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Virtual Link Trunking (VLT)