Freescale Semiconductor MPC8313E Family Reference Manual page 1205

Powerquicc ii pro integrated processor
Hide thumbs Also See for MPC8313E:
Table of Contents

Advertisement

Table 15-160. Filer Example—Interrupt from Deep Sleep (continued)
RQCTRL Fields
Table
Entry
GPI CLE REJ AND
9
0
1
0
10
0
0
0
11
0
0
0
12
0
0
0
13
0
0
0
14
1
0
0
15
0
0
0
16
0
0
0
17
1
0
0
18
0
1
1
19
0
0
1
15.6.4.3.1, 15-174
MPC8313E PowerQUICC II Pro Integrated Processor Family Reference Manual, Rev. 3
Freescale Semiconductor
Q
CMP
PID
1
000_000
00
1011
1
000_000
00
0011 0x00XX_XXXX Compare upper L2 DA bits to XX_XXXX (for
1
000_000
00
0100 0x00YY_YYYY Compare lower L2 DA bits to YY_YYYY
1
000_000
00
1100
1
000_000
00
1110
0
000_001
00
1111
1
000_000
00
0011 0x00XX_XXXX Compare upper L2 DA bits to XX_XXXX (for SNMP
1
000_000
00
0100 0x00YY_YYYY Compare lower L2 DA bits to YY_YYYY.
0
000_001
00
1110
0
000_000
01
0000
0
000_000
01
0000
Replace entire (note deleted paragraph) section, "Priority-Based Queuing (PBQ),"
to read as follows:
"PBQ is the simplest scheduler decision policy. The enabled TxBD rings are
assigned a priority value based on their index. Rings with a lower index have
precedence over rings with higher indices, with priority assessed on a
frame-by-frame basis. For example, frames in TxBD ring 0 have higher priority
than frames in TxBD ring 1, and frames in TxBD ring 1 have higher priority than
frames in TxBD ring 2, and so on.
RQPROP
0x0000_0011
Check against UDP protocol; if this passes, enter
the cluster - all packets in the cluster are IPv4
packets with UDP protocol identified as the L4
protocol type.
multicast DNS query)
0xZZZZ_ZZZZ Compare L3 Destination IP address to
ZZZZ_ZZZZ
0x0000_XXXX Compare L4 destination port to XXXX
0x0000_YYYY If all of the previously consecutive ANDed
conditions pass, multicast DNS Query has
matched.
broadcast query).
0x0000_ZZZZ If all of the previously consecutive ANDed
conditions pass, SNMP broadcast Query has
matched.
0x0000_0000 Cluster End: IPv4, UDP Comparison
Default rule that will always discard the packet;
inserted here because an IPv4 packet with
L4=UDP request was received, but the profiles
didn't match anything "interesting"; therefore drop
the packet and exit the cluster.
0x0000_0000 Default rule that will always discard the packet;
inserted here no matches for any "interesting"
packets were received that are used to wake up the
CPU. All packets that reach this rule are discarded.
Revision History
Comment
A-27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mpc8313

Table of Contents