Fujitsu MB86R02 Jade-D Hardware Manual page 540

MB86R02 'Jade-D' Hardware Manual V1.64
DC_LogOutAddr (Format5)
31
OverlapXYOfft
000000
The DC_LogOutAddr command sets the starting address of the log output destination of the device
coordinates.
SetModeRegister (Format5)
31
SetModeRegister
The SetModeRegister command sets the mode register for shade primitive, for edge primitive and for top-left
non-applicable primitive. At drawing of these primitives, also set the mode register (MDR1/MDR2) for the body
primitive, using this packet.
Command:
Command
MDR1
MDR1S
MDR1B
MDR2
MDR2S
MDR2LT
SetGModeRegister (Format5)
31
SetGModeRegister
The SetGModeRegister command sets the geometry extended mode register.
Command:
Command
GMDR1E
GMDR2E
18-182
24 23
Command
24 23
Command
Code Explanation
0000_0000 MDR1 command sets MDR1 for the body primitive.
0000_0010 MDR1S command sets MDR1 for the shade primitive.
0000_0100 MDR1B command sets MDR1 for the edge primitive.
0000_0001 MDR2 command sets MDR2 for the body primitive.
0000_0011 MDR2S command sets MDR2 for the shade primitive.
0000_0111 MDR2LT command sets MDR2 for the top-left non-applicable primitive.
24 23
Command
GMDR1E/GMDR2E
Code Explanation
0001_0000 GMDR1E command sets GMDR1E and at the same time, updates
GMDR1.
0010_0000 GMDR2E command sets GMDR2E and at the same time, updates
GMDR2.
16 15
Reserved
LogOutAddr
16 15
Reserved
MDR1*/MDR2*
16 15
Reserved
0
0
0