Ip Pimsm Query-Interval; Ip Pimsm Spt-Threshold - Dell Force10 S2410-01-10GE-24P Command Reference Manual

ip pimsm query-interval

Syntax
Default
Mode
Command
History
Related
Commands

ip pimsm spt-threshold

Syntax
Default
Mode
ip pim-trapflags
Syntax
Default
Mode
Usage
Information
| PIM Commands
492
This command configures the transmission frequency of hello messages in seconds between PIM
enabled neighbors. This field has a range of 10 to 3600 seconds.
ip pimsm query-interval
10-3600
The no ip pimsm query-interval command resets the transmission frequency of hello messages
between PIM enabled neighbors to the default value.
30
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
This command is used to configure the Threshold rate for the RP router to switch to the shortest path.
The rate is specified in Kilobytes per second. The possible values are 0 to 2000.
ip pimsm spt-threshold 0-2000
The no ip pimsm spt-threshold command is used to reset the Threshold rate for the RP router to
switch to the shortest path to the default value.
50
Global Config
This command enables the PIM trap mode for both Sparse Mode (SM) and Dense Mode. (DM).
[no] ip pim-trapflags
The no version of this command disables the PIM trap mode.
disabled
Global Config
Use this command in conjunction with other SNMP management commands, described in
Management Commands on page
Added Interface Range and Interface VLAN modes.
77.
SNMP