Snmp Event Manager Configuration Mode; Statistics Profile Configuration Mode; Subinterface Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

SNMP Event Manager Configuration Mode

In this mode, you can configure certain SNMP triggers for events, what occurs when
an event is triggered, resource limits for triggers, and some trap notification options.
From Global Configuration mode, type the snmp-server management-event
command and then press Enter.
host1(config)#snmp-server management-event
host1(config-mgmtevent)#?

Statistics Profile Configuration Mode

In this mode, you can configure a statistics profile. You can then set the rate period
during which statistics are gathered, enable statistics gathering, and enable the
counting of drop and forwarding events.
From Global Configuration mode, type statistics-profile and the statisticsProfileName
that you want to create or configure, and press Enter.
host1(config)#statistics-profile statpro-1
host1(config-statistics-profile)#?

Subinterface Configuration Mode

In this mode, you can configure one or more virtual interfaces, called subinterfaces,
on a single physical interface. The system supports this feature with ATM and Frame
Relay.
default Set a command to its default(s)
do Run an exec mode command (alias command run)
event Specify what happens when an event is triggered
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
resource Specify the resource limits
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
trigger Specify the conditions that lead to events
committed-drop-threshold
conformed-drop-threshold
default
do
exceeded-drop-threshold
exit
forwarding-rate-threshold
help
log
macro
no
rate-period
run
sleep
Chapter 2: Command-Line Interface
Set threshold for logging a committed-drop event
Set threshold for logging a conformed-drop event
Set a command to its default(s)
Run an exec mode command (alias command run)
Set threshold for logging an exceeded-drop event
Exit from the current command mode
Set threshold for logging a forwarding-rate event
Describe the interactive help system
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Set the time period for calculating queue rates
Run an exec mode command (alias command do)
Make the Command Interface pause for a specified
duration
Accessing Command Modes
119