Tray 5 Undocked During Run Rap - Xerox WorkCentre 5687 Series Service Manual

07-372 Tray 5 Undocked During Run RAP

07-372 Tray 5 was undocked during run when the paper is fed from tray 5.
Initial Actions
• Ensure the tray is pushed fully home, Figure 1.
• Check for obstructions between the tray and the machine.
Procedure
Enter dC330 code 07-372 tray 5 docking switch, S07-372. Press Start. Undock and dock tray
5, refer to REP 7.19. The display changes.
Y N
Go to Flag 1. Check S07-372. Refer to:
• GP 13 How to Check a Switch.
• P/J507, Tray 5 control PWB.
• 01E +5V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Tray 5 docking switch, PL 7.64 Item 1
• Tray 5 control PWB, PL 7.68 Item 8
Perform the following:
• Check the docking latch on tray 5 is latched onto the machine, Figure 2.
• Check the that the rail assembly is located correctly to the machine.
Status Indicator RAPs
07-372
Tray 5 docking location pin
Figure 1 Component location
August 2007
2-164
Tray 5 docking
switch S07-372
WorkCentre 5687 Family