Xerox WorkCentre 5687 Series Service Manual page 378

Y N
Go to Flag 3. Check MOT08-025. Refer to:
• GP 10 How to Check a Motor.
• P/J273, Tray 1 and 2 control PWB.
• 01G +24V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Tray 1 and 2 transport motor, (32-55 ppm) PL 8.25 Item 5.
• Tray 1 and 2 control PWB, PL 7.10 Item 2.
The transport rolls rotate.
Y N
Check the drive belt and gears, GP 7, PL 8.25 Item 2, PL 8.25 Item 3.
Check the following:
• The bearing, shaft and rolls on the transport roll assembly, GP 7, (32-55 ppm) PL 8.25
Item 8.
• The idler rolls in the left hand door, GP 7, PL 7.30 Item 2.
• The transport drive belt, (32-55 ppm) PL 8.25 Item 2.
• The transport rolls for wear, PL 8.25 Item 8.
Install new components as necessary.
Status Indicator RAPs
08-100A
Tray 1 and 2 transport motor
MOT08-025
Tray 1 feed sensor
Q08-101
Figure 1 Component location
August 2007
2-186
Wait sensor
Q08-100
WorkCentre 5687 Family