08-107 Tray 3 Paper Feed Jam RAP
08-107 The lead edge of the paper was late to tray 4 feed sensor when feeding from tray 3.
Initial Actions
•
Check the condition of the paper in tray 3. Refer to IQ1 and GP 20.
•
Check for obstructions in tray 3 paper path, Figure 2.
•
Check the tray 4 feed sensor, Figure 1.
•
Ensure that the tray is pushed fully home.
Procedure
NOTE: The front door interlock must be cheated when checking +24V components.
Enter dC330 code 08-104 tray 4 feed sensor, Q08-104. Press Start. Manually actuate the tray
4 sensor. The display changes.
Y
N
Go to Flag 1. Check Q08-104. Refer to:
•
GP 11 How to Check a Sensor.
•
P/J392, HCF control PWB.
•
01E +5V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Tray 4 feed sensor, PL 8.31 Item 10.
•
HCF control PWB, PL 7.20 Item 2.
Enter dC330 code 08-045 tray 3 and 4 transport motor, MOT08-045. Press Start. The
runs.
Y
N
Go to Flag 2. Check MOT08-045. Refer to:
•
GP 10 How to Check a Motor.
•
P/J398, HCF control PWB.
•
01G +24V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Tray 3 and 4 transport motor, PL 8.30 Item 7.
•
HCF control PWB, PL 7.20 Item 2.
The transport rolls rotate.
Y
N
Figure 2. Check drive belt and drive coupling, PL 8.30 Item 9.
Perform the following:
•
Figure 2. Check tray 3 transport rolls, PL 8.35, PL 8.30.
•
Go to RAP 08-103, 08-113 Tray 3 Misfeed RAP.
Status Indicator RAPs
08-107
Tray 3 and 4 trans-
port motor
MOT08-045
motor
Figure 1 Component location
August 2007
2-200
Tray 4 feed
sensor
Q08-104
WorkCentre 5687 Family