08-182 Unexpected Time Out in Duplex Mode RAP
08-182 The IOT detected an unexpected time out for a known duplex sheet of paper.
Initial Actions
•
Enter the machine status mode and check for the active messages. Refer to OF4 Status
Codes and Message RAP for the jam clearance procedure.
•
Check the condition of the paper in all trays. Refer to IQ1 and GP 20.
•
Check for obstructions in the duplex paper path.
Procedure
If the initial actions did not resolve the problem. Switch off the machine, then switch on the
machine, GP 14. If a fault code is displayed then go to the appropriate RAP.
Status Indicator RAPs
08-182, 08-190
08-190 Post Jam Clearance Initialization RAP
08-190 A stray sheet has been detected in either the IOT or finisher device during the post jam
clearance initialization routine.
Initial Action
•
Enter the machine status mode and check for the active messages. Refer to OF4 Status
Codes and Message RAP for the jam clearance procedure.
•
Check for paper in the machine paper path at all the sensor locations.
•
Check for paper in the finisher paper path at all the sensor locations. Use a flashlight to
check that the hole punch sensor is clear.
–
2K LCSS, PL 11.6 Item 7.
–
HVF, PL 11.153.
–
HCSS BM, PL 11.70 Item 9.
•
Make sure that all the covers and paper guides are closed, and latched correctly.
Procedure
If the initial actions did not correct the problem. Switch off the machine, then switch on the
machine, GP 14. If a fault code is displayed then go to the appropriate RAP.
August 2007
2-230
WorkCentre 5687 Family