Figure 2 Circuit diagram
Status Indicator RAPs
09-341, 09-342, 09-345, 09-346
09-345, 09-346 Transfer / Detack Cleaning Failure RAP
09-345 The transfer / detack cleaning routine has failed to complete. The home sensor is not
detected.
09-346 A transfer / detack cleaning warning detected. Home sensor detected, but may not be
cleaning the full length of the wires.
Initial Actions
•
Check that the transfer / detack corotron is installed correctly.
•
Check the cleaner drive coupling under the transfer / detack corotron for damage and it
moves freely.
•
Check the transfer / detack cleaner drive shaft, Figure 1.
•
Check the transfer / detack home sensor actuator is not damaged.
Procedure
NOTE: The front door interlock must be cheated when checking +24V components.
Enter dC330 code 09-074 transfer / detack stall sensor. Press Start.
Enter dC330 code 09-075 transfer / detack cleaner motor. Press Start.
When the motor reaches the end of its travel, the stall sensor will go high / low. The
runs and the stall sensor goes high / low.
Y
N
Go to Flag 2. Check MOT09-043. Refer to:
•
GP 10 How to Check a motor.
•
P/J65, IOT PWB.
•
01G +24V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Transfer / detack motor (45-87 ppm), Figure 1, part of PL 10.25 Item 1.
•
Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL
1.10 Item 2.
Remove the transfer / detack corotron. Enter dC330 code 09-073 transfer / detack cleaner
home sensor, Figure 1. Press Start. Manually actuate the sensor The display changes.
Y
N
Go to Flag 1. Check Q09-070. Refer to:
•
GP 11 How to Check a Sensor.
•
P/J65, IOT PWB.
•
01D +3.3V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Transfer / detack cleaner home sensor, (45-87 ppm), Figure 1, part of PL 10.25 Item
1
•
Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL
1.10 Item 2.
A
August 2007
2-238
motor
WorkCentre 5687 Family