Figure 2 Circuit diagram
Status Indicator RAPs
08-150A, 08-151A, 08-150B, 08-151B
08-150B, 08-151B Registration Jam RAP (65-87 ppm)
08-150 The lead edge of the paper failed to actuate the registration sensor within the correct
time after the paper was released from the wait point.
08-151 The trail edge of the paper was late to the registration sensor after the registration
clutch, CL08-070 on.
Initial Actions
•
Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 08-
150, 08-151 Registration Jam Entry RAP.
•
Check the condition of the paper in all trays. Refer to IQ1 and GP 20.
•
Check for obstructions in the paper path.
•
Check that the left hand door is latched correctly.
•
Check that the interlock cover has not come loose, PL 7.30 Item 23. Bias the cover to the
right and tighten the two screws
•
Check that the short paper path assembly latches without excessive force, PL 10.25 Item
1. Go to REP 10.1. In Replacement Step 5, check the latch mechanism.
•
If the fault code is 08-151 and two sheets of paper are jammed at the registration rolls. Go
to OF8 Multifeed RAP.
•
If the fault code 08-151 occurs from the bypass tray. Go to the 07C Bypass Tray RAP.
•
If the power and control assembly has been moved prior to a 08-150. Check that PJ148 is
pushed fully home on the Main Drives PWB.
•
Check the transport drive belt.
•
Ensure that all connectors on the tray 1 and 2 Control PWB, PL 7.10 Item 2 and on the
IOT PWB, PL 1.10 Item 2 are correctly and securely seated.
Procedure
NOTE: Ensure that the front door interlock is cheated when checking +24V components.
Enter dC330 code 08-150 registration sensor, Q08-150. Press Start. Figure 1. Open the left
hand door and activate the registration sensor. The display changes.
Y
N
Go to Flag 1. Check Q08-150. Refer to:
•
GP 11 How to check a Sensor.
•
P/J16, IOT PWB.
•
01E +5V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Registration sensor, (65-87 ppm) PL 8.17 Item 3.
•
Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL
1.10 Item 2.
Enter dC330 code 08-100 wait sensor, Q08-100. Press Start.
Open the left hand door and activate the wait sensor. The display changes.
August 2007
2-214
WorkCentre 5687 Family