Xerox WorkCentre 5687 Series Service Manual page 364

07A Tray 1 and Tray 2 Empty RAP
Use this RAP when the copier display instructs the operator to add paper to the tray that is not
empty.
NOTE: Tray 1 and tray 2 feed mechanisms are identical.
Procedure
Pull out the relevant tray.
Enter the relevant code to monitor the tray empty sensor:
Tray 1 empty sensor, Q07-331. Enter dC330 code 07-331. Press Start.
Tray 2 empty sensor, Q07-332. Enter dC330 code 07-332. Press Start.
Manually actuate the tray empty sensor. The display changes.
Y N
Tray 1: Go to Flag 1. Check S07-331. Tray 2: Go to Flag 2. Check Q07-332. Refer to:
• GP 11 How to Check a Sensor.
• Tray 1 P/J274, Tray 1 and 2 control PWB.
• Tray 2 P/J275,Tray 1 and 2 control PWB
• 01E +5 V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary.
• Tray 1 empty sensor, Figure 1, PL 8.26 Item 8.
• Tray 2 empty sensor, Figure 1, PL 8.26 Item 8.
• Tray 1 and 2 control PWB, PL 7.10 Item 2.
Perform the following:
• Check that the sensor is free of paper dust.
• Check the paper feed mechanism, PL 8.26 Item 1.
Tray 1 empty sensor Q07-331
Tray 2 empty sensor Q07- 342
Figure 1 Component location
Status Indicator RAPs
07A
Figure 2 Tray 1 circuit diagram
August 2007
2-172 WorkCentre 5687 Family