Xerox WorkCentre 5687 Series Service Manual page 424

A
Y N
Install a new transfer / detack harness, (32-38 ppm), PL 9.22 Item 9, (45-87), PL
9.20 Item 9.
On the 32-38 ppm machine, install a new transfer / detack corotron, PL 9.22 Item 8. On
the 45-87 ppm machine, install a new short paper path assembly, PL 9.20 Item 3.
If the fault continues, install a new HVPS PL 1.10 Item 5.
Add component code 09-065 registration chute bias. Press start. Time out after 90 seconds.
The display for code 09-060 is low.
Y N
Install a new HVPS PL 1.10 Item 5.
Add component code 09-066 developer bias. Press start. Time out after 3 seconds. The
play for code 09-060 is low.
Y N
Go to Flag 3. Check the developer bias harness for short circuit to ground, GP 7. The
developer harness and connectors are good.
Y N
Install a new developer bias harness, (32-55 ppm) PL 9.17 Item 6, (65-87 ppm) PL
9.15 Item 6.
Install a new HVPS PL 1.10 Item 5.
Complete SCP 6 Final Actions.
Status Indicator RAPs
09-060
dis-
Figure 1 Component location (45-87 ppm)
August 2007
2-232
Transfer corotron connector
Detack corotron connector
Charge Grid connector. The two
terminals identified as G are the
same output.
Charge scorotron connector
P/J55
Developer bias connector
Registration and transfer chute bias
connector. The two terminals identi-
fied as CB are the same output.
WorkCentre 5687 Family