Toyota Celica 2005 Repair Manual page 1000

INSPECTION PROCEDURE
1 Check other DTCs output (in addition to DTC P0711)
PREPARATION:
(a) Warm up the engine.
(b) Turn the ignition switch off.
(c) Connect the OBD II scan tool or hand−held tester to the DLC3.
(d) Turn the ignition switch to the ON position.
(e) Push the "ON" button of the OBD II scan tool or the hand−held tester.
(f) Select the item "DIAGNOSIS/ENHANCED OBD II/DTC INFO/CURRENT CODES".
CHECK:
Read the DTCs using the OBD II scan tool or the hand−held tester.
RESULT:
Only "P0711" is output
"P0711" and other DTCs
HINT:
If any other codes besides "P0711" is output, perform the troubleshooting for those DTCs first.
A
2 Check transaxle fluid level
OK
Replace the transmission wire (ATF tempera-
ture sensor) (See page AX−5).
2005 CELICA (RM1131U)
DIAGNOSTICS
Display (DTC output)
(See page DI−758).
− AUTOMATIC TRANSAXLE (U341E)
B Go to relevant DTC chart (See page DI−781).
NG Add fluid (See page DI−758).
999
Proceed to
A
B
DI−799