Cvu Commands - Keithley 4200A-SCS Reference Manual

Model 4200A-SCS Parameter Analyzer Reference Manual
Command
pulse_range
13-149)
pulse_rise
150)
pulse_ssrc
151)
pulse_trig
152)
pulse_trig_output
page 13-153)
pulse_trig_polarity
page 13-154)
pulse_trig_source
page 13-155)
pulse_vhigh
157)
pulse_vlow
157, on page 13-159)
pulse_width
161)
seg_arb_define
13-162)
seg_arb_file
13-165)

CVU commands

Command
adelay (on page 13-59)
asweepv
bsweepX
cvu_custom_cable_comp
page 13-170)
devclr (on page 13-67)
devint (on page 13-13)
dsweepf (on page 13-172)
dsweepv
forcev (on page 13-175)
getstatus
measf (on page 13-177)
meast (on page 13-177)
measv (on page 13-178)
measz (on page 13-178)
rangei (on page 13-179)
4200A-901-01 Rev. C / February 2017
Description
(on page Sets a pulse card channel for low voltage (fast speed) or high voltage (slow speed).
(on page 13- Sets the rise transition time for the pulse card pulse output.
(on page 13- Controls the high-endurance output relay (HEOR) for each output channel of the
PGU.
(on page 13- Selects the trigger mode (continuous, burst, or trigger burst) and initiates the start of
pulse output or arms the pulse card.
(on Sets the output trigger on or off.
(on Sets the polarity (positive or negative) of the pulse card output trigger.
(on Sets the trigger source.
(on page 13- Sets the pulse voltage high level.
(on page 13- Sets the pulse voltage low value.
(on page 13- Sets the pulse width for pulse output.
(on page
Defines the parameters for a Segment Arb
(on page
Used to load a waveform from an existing Segment Arb
Description
Specifies an array of delay points to use with asweepX command calls.
(on page 13-167) Does a DC voltage sweep using an array of voltage values.
(on page 13-65) Supplies a series of ascending or descending voltages or currents and shuts
down the source when a trigger condition is encountered.
(on Determines the delays needed to accommodate custom cable lengths.
Sets all sources to a zero state.
Resets all active instruments in the system to their default states.
Performs a dual frequency sweep.
(on page 13-174) Performs a dual linear staircase voltage sweep.
Sets the DC bias voltage level.
(on page 13-176) Returns various parameters pertaining to the state of the 4210-CVU.
Returns the frequency sourced during a single measurement.
Returns a timestamp referenced to a measurement or a system timer.
Returns the DC bias voltage sourced during a single measurement.
Makes an impedance measurement.
Selects an impedance measurement range.
Section 13: LPT library function reference
®
waveform.
®
waveform file.
13-7