Keithley 4200A-SCS Reference Manual page 422

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Choose the stress mode

You can select one of these stress, measure, or cycle modes:

Stress/Measure Mode: Test-stress-test-stress cycles, such as hot carrier injection (HCI) or

negative bias temperature instability (NBTI) studies.

Segment Stress/Measure Mode: Stress/Measure mode for a segment. Segment Stress/measure

mode is similar to the Stress/Measure Mode, except device stressing is provided by pulse cards

using the Segment Arb

for the devices, but you cannot use them to measure stress.

Cycle Mode: Repeats cycles through the subsite tests without stressing the devices.

To choose the stress-cycle mode:

1. From the project tree, select the subsite.

2. Select Configure.

3. In the right pane, select Stress Mode Setup.

4. Select Enable Stress/Measure/Cycles.

5. Select the Stress/Measure Mode, Segment Stress/Measure Mode, or Cycle Mode.

4200A-901-01 Rev. C / February 2017

pulse mode. You can use SMUs to provide bias voltage and current limit

Figure 313: Stress Mode Setup pane

Section 6: Clarius