Dev_Abort - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Section 13: LPT library function reference

dev_abort

This command programmatically ends a test from within the user module (aborts a test) that was started with the

pulse_exec command.

int dev_abort(NULL);

Standard and Segment Arb

Use this command to abort a pulse test from in a user module. This command is useful during a

longer pulse_exec test. Note that pulse_exec is nonblocking, so it is possible to fetch data during

a longer test. An example of this is a long stress/measure test, using seg_arb_sequence and

seg_arb_waveform, that evaluates degradation data intra-test. Evaluating this data from within the

user module may determine that a test should end. For example, if the degradation is greater than ten

percent (>10%), then end the test to save test time.

Model 4200A-SCS Parameter Analyzer Reference Manual

4200A-901-01 Rev. C / February 2017