Starting Kxci And The Gpib Command Interpreter - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Starting KXCI and the GPIB command interpreter

You cannot run Clarius and KXCI at the same time. When Clarius is running, the 4200A-SCS is the

controller and controls all internal and external instruments. When KXCI is running, the 4200A-SCS

is a subordinate to a controlling computer over GPIB or ethernet.

To start KXCI:

1. Close Clarius.

2. Select the KXCI icon on the desktop.

The KXCI user interface opens.

The GPIB Status Indicators only apply if communications is set to GPIB.

For further information about controlling the 4200A-SCS through ethernet, refer to

4200A-901-01 Rev. C / February 2017

Figure 462: KXCI user interface

(on page 9-2) and

KXCI ethernet client driver

Section 9: Keithley External Control Interface (KXCI)

(on page 9-87).

Communications