Keithley 4200A-SCS Reference Manual page 672

Model 4200A-SCS Parameter Analyzer Reference Manual
15. In the Test Settings pane, select the my_1st_lib user library.
16. From the User Modules list, select the TwoTonesTwice user module. A group of parameters are
displayed for the UTM as shown in the following figure. Accept the default parameters for now.
You can experiment later after you establish that the user module executes correctly.
17. Select Help to verify that the HTML in the Description tab is correctly formatted. An example is
shown in the following figure.
18. Select Save.
19. Execute the UTM by selecting Run. You should hear a sequence of four tones, sounded at
alternating frequencies.
This tutorial generates no data. For an example of numerical data, see
module that returns data arrays
4200A-901-01 Rev. C / February 2017
Figure 438: Configured UTM
Figure 439: Example of help formatted as HTML for a user module
(on page 8-28).
Section 8: Keithley User Library Tool (KULT)
Tutorial 2: Creating a user
8-27