Appendix F: Set up a probe station
Test system connections
A typical test system for this tutorial is shown in the following figure. The 4200A-SCS and probe
station are connected to a 7174A matrix card. The matrix card is installed in the switch matrix, and
the switch matrix and probe station are controlled through the GPIB bus.
KCon setup
Refer to
Use KCon to add a switch matrix to the system
F-16
Figure 630: System configuration for the probesubsites project
Model 4200A-SCS Parameter Analyzer Reference Manual
(on page A-24).
4200A-901-01 Rev. C / February 2017