Keithley 4200A-SCS Reference Manual page 1096

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Appendix B: Using a Model 590 C-V Analyzer

Figure 548: Basic 590 connections to the DUT

Triaxial connectors

Adapters are required to connect the 590 to equipment (for example, a probe station, test fixture, or

matrix card) that uses triaxial connectors. The 7078-TRX-BNC is a 3-lug triaxial to BNC adapter. As

shown in the following figure, connect the adapters to the 3-slot triaxial connectors and then use a

7051 BNC cable to make the connections to the 590.

Using Switch Matrices

(on page A-1) for details on using a switch matrix with the 590 C-V

Figure 549: Connecting the 590 to equipment with triaxial connectors

The figure below shows the equivalent circuit for the adapter.

Figure 550: 7078-TRX-BNC equivalent circuit

GPIB connections

The 4200A-SCS controls the 590 through the General Purpose Interface Bus (GPIB). Use the 7007-1

or 7007-2 GPIB cable to connect the GPIB of the 590 to the GPIB of the 4200A-SCS.

4200A-901-01 Rev. C / February 2017