Keithley 4200A-SCS Reference Manual page 1111

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Appendix B: Using a Model 590 C-V Analyzer

This user module performs a capacitance versus time (Ct) sweep. The figure below shows the default

parameters for the ctsweep-590 UTM, which uses the CtSweep590 user module.

Output: The measured array of capacitance values

Set to a value that at minimum is equal to the Count; if in doubt, set to 1350

When the parallel measurement model (1) is selected, G_or_R is the

measured conductance

When the series measurement model (0) is selected, this is the measured

Set to a value that at minimum is equal to the Count; if in doubt, set to 1350

The array of time stamps for each measurement step

Set to a value that at minimum is equal to the Count; if in doubt, set to 1350

Figure 562: Starting KULT

Model 4200A-SCS Parameter Analyzer Reference Manual

4200A-901-01 Rev. C / February 2017