Connection Scheme Settings - Keithley 4200A-SCS Reference Manual

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Appendix A: Using switch matrices

The following figure shows connections for remote (4-wire) sensing.

Figure 528: Test connections for a switch matrix - remote (4-wire) sensing

The 7078-TRX-BNC adapters must be used in order to extend SMA shielding through the matrix

The shields of the SMA cables must be connected together and extended as far as possible to the

DUT, as shown in

Connection scheme settings

The following connection scheme settings are set from the Keithley Configuration Utility (KCon) when

the switch matrix is added to the system configuration. See

(on page A-24).

Typical 4210-CVU test connections to a DUT

Model 4200A-SCS Parameter Analyzer Reference Manual

(on page 4-6).

Using KCon to add a switch matrix to the

4200A-901-01 Rev. C / February 2017