Keithley 4200A-SCS Reference Manual page 1055

Section 13: LPT library function reference
Code
-104
-105
-106
-107
-108
-109
-110
-111
-113
-114
-115
-116
-117
-118
-119
-120
-121
-122
-124
-126
-129
-137
-138
-139
-140
-141
-142
-143
-152
-153
-154
-155
-158
-159
-160
-161
-164
-165
-166
-167
-169
-190
-191
-192
-200
13-210
Status or error titles
Unrecognized instrument or terminal not connected to matrix, argument #%d.
No pathway assigned to argument #%d.
Path %d previously allocated.
Not enough pathways to complete connection.
Argument #%d is not defined by configuration.
Illegal test station: %d.
A ground connection MUST be made.
Instrument low connection MUST be made.
There are no switching instruments in the system configuration.
Illegal connection.
Operation not allowed on a connected pin: %d.
No physical bias path from %s to %s.
Connection cannot be made because a required bus is in use.
Cannot switch to high current mode while sources are active.
Pin %d in use.
Illegal connection between %s and GNDU.
Too many calls were made to trigXX.
Illegal value for parameter #%d.
Sweep/Scan measure table overflow.
Insufficient user RAM for dynamic allocation.
Timer not enabled.
Invalid value for modifier.
Too many points specified in array.
An error was encountered while accessing the file %s.
%s unavailable while slaved to %s.
Timestamp not available because no measurement was made.
Cannot bind, instruments are incompatible.
Cannot bind, services unavailable or in use.
Function not supported by %s (%d).
Instrument with ID %d is not in the current configuration.
Unknown instrument name %s.
Unknown instrument ID %i.
VXI device in slot %d failed selftest (mfr ID: %04x, model number: %04x).
VME device with logical address %d is either non-VXI or non-functional.
Measurement cannot be performed because the source is not operational.
Instrument in slot %d has non-functional dual-port RAM.
VXI device in slot %d statically addressed at reserved address %d.
Service not supported by %s (%d).
Instrument with model code %08x is not recognized.
Invalid instrument attribute %s.
Instrument %s is not in the current configuration.
Ill-formed connection.
Mode conflict.
Instrument sense connection MUST be made.
Force value too big for highest range %g.
Model 4200A-SCS Parameter Analyzer Reference Manual
4200A-901-01 Rev. C / February 2017