Keithley 4200A-SCS Reference Manual page 1281

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Appendix H: Using a Micromanipulator 8860 Prober

3. Set units of measure (microns or mils).

4. Calculate the wafer diameter:

Move the pins to the left edge of the wafer.

Click Left on the Setup Options window.

Repeat for the top and right edges of the wafer, clicking the respective buttons after each movement.

Click the Calculate button.

5. Set units to either microns or mils from the units of measure Units list in Setup Options window.

See the following two figures.

Model 4200A-SCS Parameter Analyzer Reference Manual

Figure 708: PcWfr window

Figure 709: Units of measure list

Figure 710: Setup Options window

4200A-901-01 Rev. C / February 2017