Keithley 4200A-SCS Reference Manual page 739

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Section 9: Keithley External Control Interface (KXCI)

This command sets the time duration spent on each step of the sweep for a VAR1 sweep.

For a VAR1 sweep, the time spent on each step of the sweep is determined by the user-set delay

time and the time it takes to make a measurement.

You typically use the delay time to allow the source to settle before making a measurement. For

example, assume a delay time of 1 s. At each step of the sweep, the source is allowed to settle for

1 s before the measurement is made.

This command string sets delay time to 1 s.

Measurement setup page (SM)

Use the command strings for the SM page for the following operations:

Set wait time

Set interval

Select number of readings

Select list display mode

To send the following command strings to the 4200A-SCS, select the SM page by sending the

Delay time in seconds: 0 to 6.553

Model 4200A-SCS Parameter Analyzer Reference Manual

4200A-901-01 Rev. C / February 2017