Keithley 4200A-SCS Reference Manual page 480

Hide thumbs Also See for 4200A-SCS:

Table of Contents

Model 4200A-SCS Parameter Analyzer Reference Manual

Interpolate data on the graph

You must select a cursor before the move or interpolation key sequences become active for that

To add data on the graph:

Select a cursor, hold the Alt key, and use the arrow keys to find the point for which you want to

interpolate data.

Note that the highlighted cursor is between points and the label has a * before the data to indicate it

is an interpolated value.

To step between data points as listed in the Run sheet, hold the Ctrl key and use the arrow keys.

You can select cursors using the Tab key. Press the Tab key to select the next cursor if more

than one cursor is displayed.

If you hold the Ctrl or Alt and Arrow key for more than a second, the cursor moves more quickly. The

cursor moves 1 pixel at a time in normal mode and 5 pixels at a time in fast mode.

To enlarge an area of the graph:

1. Click the graph where you want to zoom. A magnifying glass is displayed.

2. Drag the magnifying glass over the data you want to enlarge, as shown in the example here.

The axis scales adjust automatically. By zooming in multiple times, you can observe a small portion

of the graph.

4200A-901-01 Rev. C / February 2017

Figure 368: Zoom in on an area of the graph

Section 6: Clarius