Keithley 4200A-SCS Reference Manual page 1057

Section 13: LPT library function reference
Code
-514
-515
-516
-517
-518
-519
-520
-521
-522
-523
-524
-550
-551
-552
-553
-601
-602
-603
-604
-610
-611
-612
-620
-621
-640
-641
-650
-660
-661
-662
-663
-664
-701
-702
-703
-704
-705
-706
-707
-801
-802
-803
-804
-805
-806
13-212
Status or error titles
IFC abort.
GPIB timed out.
Invalid function number.
TCT timeout.
No listeners on bus.
Driver problem.
Bad slot number.
No listen address.
No talk address.
IBUP Software configuration error.
No utility function.
EEPROM checksum error in %s: %s.
EEPROM read error in %s: %s.
EEPROM write error in %s: %s.
%s returned unexpected error code %d.
System software internal error; contact the factory.
Module load error: %s.
Module format error: %s.
Module not found: %s.
Could not start %s.
Network error.
Protocol error.
Driver load error. Could not load %s.
Driver configuration function not found. Driver is %s.
%s serial number %s failed diagnostic test %d.
%s serial number %s failed diagnostic test %d with a fatal fault.
Request to open unknown channel type %08x.
Invalid group ID %d.
Invalid test ID %d.
Ill-formed list.
Executor is busy.
Invalid unit ID %d.
Error configuring serial port %s.
Error opening serial port %s.
Call kspcfg before using kspsnd or ksprcv.
Error reading serial port.
Timeout reading serial port.
Terminator not received before read buffer filled.
Error closing serial port %s.
Exception code %d reported from VPU in slot %d, channel %d.
VPU in slot %d has reached thermal limit.
Start and stop values for defined segmented arb violate minimum slew rate.
Function not valid in the present pulse mode.
Too many points specified in array.
Not enough points specified in array.
Model 4200A-SCS Parameter Analyzer Reference Manual
4200A-901-01 Rev. C / February 2017